Filter
Top Products
3. press button 8 again to start the pro-
gramme.
Important! The selected delay can be
changed only after selecting the washing
programme again.
The Delay Start can not be selected with
the draining programme.
START THE PROGRAMME BY
PRESSING BUTTON 8
To start the selected programme, press the
button 8, the green pilot light of the button
8 stops blinking. The icon 2.8 appears on
the display to indicate that the appliance
starts operating and the door is locked.
To interrupt a programme which is running,
press the button 8: the green pilot light
starts to blink.
To restart the programme from the point at
which it was interrupted, press the button 8
again. If you have chosen a delayed start,
the machine will begin the countdown.
If an incorrect option is selected, the red pi-
lot light of the button 8 blinks for 3 times
the message Err is displayed for few sec-
onds.
SELECT THE TIME MANAGER OPTION
BY PRESSING BUTTONS 9
By pressing these buttons repeatedly, the
duration of the washing cycle can be in-
creased or decreased. The icon 2.12 will
appear on the display to indicate the chos-
en degree of soil. This option is available
only with Cotton, Syntheticand Delicate
programmes.
Soil Level Icon Type of fabric
Intensive For heavy soiled
items
Normal For normal soiled
items
Daily For daily soiled
items
Light For slightly soiled
items
Quick For very slightly
soiled items
Super Quick
1)
For items used or
worn for a short time
Refresh
1)
2)
For refreshing items
only
Soil Level Icon Type of fabric
Super Re-
fresh
1)
2)
For refreshing a very
few items only
1) We recommend you to reduce the load sizes (see
Washing programmes table).
2) When you select this option the relevant icon appears
just for a while and then it disappears immediately.
ALTERING AN OPTION OR A RUNNING
PROGRAMME
It is possible to change some options be-
fore the programme carries them out .
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton 8 (if you wish to change the Time Man-
ager option, you must cancel the running
programme and make your selection
again).
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
and then to the new pro-
gramme position. Start the new programme
by pressing the button 8 again. The wash-
ing water in the tub will be not emptied out.
INTERRUPTING A PROGRAMME
Press the button 8 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
CANCELLING A PROGRAMME
Turn the selector dial to
to cancel a pro-
gramme which is running.
You can select now a new programme.
OPENING THE DOOR
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button 8.
If the icon 2.8 disappears after some mi-
nutes, the door can be opened.
If the icon 2.8 does not go off, this means
that the machine is already heating or that
the water level is too high. Do not try to
force the door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to
. After a
few minutes the door can be opened (pay
attention to the water level and temper-
ature!).
10 electrolux