Filter
Top Products
11. How to change an option or a
programme during its cycle
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
machine by pressing the “Start/Pause” button.
Changing a running programme is possible only by
resetting it.
Turn the programme selector dial to “Off” and then
to the new programme position.
Start the new programme by depressing the
“Start/Pause” button. The washing water in the tub
will not emptied out.
12. How to cancel a programme
during its cycle
Depress the “Start/Pause” button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the button again to restart
the programme.
13. How to open a programme
during its cycle
You can open the door, after having set the washing
machine to Pause, provided the following conditions
exist:
• the machine is not in the heating phase beyond
55°C;
• the level of the water is not high;
If these requirements are met, when you pause the
washer dryer, the door can be opened.
Should it not be possible to open the door, and
should it be absolutely necessary to do so, switch
the machine off by turning the selector dial to “Off”.
After approximately 3 minutes, you can open the
door.
Pay attention to the level and temperature of the
water in the machine!
When you close the door to restart the programme
turn the dial to the previous programme repeating
the options previously selected and press
“Start/Pause” button.
14. At the end of the programme
At the end of the programme, the washer-dryer stops
automatically.
The light of the “Start/Pause” button goes off, the
pilot light “Prewash/Wash” goes off. The display will
show a flashing zero.
If you had selected the (Rinse Hold) option, the
corresponding lights will be on, the display will show
a flashing zero but the door will be locked to indicate
that the water must be drained.
To complete the cycle, there are 2 possibilities :
• turn the selector dial to the “Off” position, select
programme “Drain” and then depress the
“Start/Pause” button: the water is emptied out
without spinning.
or
• turn the selector dial to the “Off” position and then
select programme “Spin” or “Gentle Spin”. Select
the spin speed by means of the relevant button
and then depress the “Start/Pause” button. The
water is emptied out and the laundry is spun at
the selected spin speed.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get
damaged in a subsequent wash (e.g. by shrinking) or
bleed colour into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing
machine.
20