Filter
Top Products
ENGLISH
An alarm code indicates a fault in the machine
operation (see the relevant chapter, "Something
Not Working")
9 “Delay Start” button
This button makes it possible to delay the starting of the
programme 30 min - 60 min - 90 min, 2 hours and then
by 1 hour up to a maximum of 23 hours.
The delay you have selected is shown on the display
for about 3 seconds; afterwards, the duration of the
programme reappears.
You must select this option after you have set the
programme and before you press the “Start/Pause”
button.
The time value shown on the display will decrease
by one unit every hour.
You can change the delay time at any moment,
before you press the “Start/Pause” button.
If you have already pressed the “Start/Pause” button,
and you wish to cancel the delay time, proceed as
follows:
• set the machine to PAUSE by pressing the
“Start/Pause” button;
• press the “Delay Start” button until the symbol
0 is
displayed.
• press the “Start/Pause” button again.
Important!
• The “Delay Start” cannot be used with “Drain”,
“Spin” or “Gentle Spin” programmes.
10 “Start/Pause” button
This button has two functions:
• Start: after you have selected the desired
programme and options, press this button to start
the machine. The light above the button will stop
flashing and remain lit.
If you have selected a delay time by means of
button 9, the countdown will begin and will be
shown on the display.
• Pause: when you press this button again, the
programme in progressis interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, and it becomes
possible to open the door, provided
• the machine is not in the heating or drying phase;
• the level of the water is not high;
• the drum is not turning.
Important!
You must set the machine to PAUSE before you
make any change in the programme in progress.
11 Programme phase indicator
lights
When you select a programme, the lights relevant to
the phases that form the programme light up.
After you have started
the programme, only the
light relevant to the
phase that is currently
being carried out will
remain lit.
Drying
Drain
Spinning
Rinses
Prewash/Wash
Start/
Pause
13