Filter
Top Products
While the programme is running (after you have
pressed the Start/Pause button), the displayed time
value decreases by one unit every minute.
• The washer-dryer has stopped with water in the
tub, at the end of a programme with option
selected: this is indicated by a flashing zero.
• The washer-dryer has completed the
programme: this is indicated by a flashing zero.
After starting the programme, the remaining time is
updated every minute.
• Selection of drying time in minutes.
After starting the programme, the remaining time is
updated every minute.
Important!
If you select a drying time longer then 55’
minutes, after 3 seconds, the display will show it
in hours and minutes (see the example below).
Example:
• Delay start, a time value indicated in hours (23
hours max) and selected by means of the relevant
button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the Start/Pause button, the
countdown is updated every hour, and, for the last
two hours, every 30 minutes.
• An incorrect option selection has been made:
this is indicated by the message Err when a
function incompatible with the current programme
is selected.
•
12