Filter
Top Products
After a IronAid pro-
gramme, garments are
not sufficiently smooth.
Wrong programme selected (e.g.
SYNTHETICS instead of
COTTON).
Note the composition of the fabric.
Too low a LOAD level set. Set a higher LOAD level.
Too many garments in machine, or
garments that are too different.
Load the machine with fewer gar-
ments, or only similar ones.
Clothes are not removed until the
anti-crease phase is finished.
Remove clothes quickly one at a
time from the machine as soon as
possible after the start of the anti-
crease phase.
Garments not hung on clothes
hangers and/or not tugged into
shape.
Hang garments on clothes hang-
ers, do up buttons and tug gar-
ments into shape.
Multi-layered garments tend to lose
their shape.
Reshape multi-layered garments by
ironing after they come out of the
machine.
After a IronAid pro-
gramme, there are no
creases left in the gar-
ments.
The IronAid programme has the ef-
fect of smoothing garments.
Iron creases in again after the Iron-
Aid programme.
Drying results unsatisfac-
tory.
Wrong programme selected.
Select a different programme the
next time you dry (see “Programme
overview” chapter).
Lint filters clogged. Clean lint filters.
Fluff filter clogged. Clean fluff filter.
Heat exchanger clogged with lint. Clean heat exchanger.
Overloading of laundry.
Observe recommended loading
volumes.
Ventilation slots in base area cov-
ered up.
Uncover ventilation slots in base
area.
Residue on inside surface of drum
or drum ribs.
Clean inside surface of drum and
drum ribs.
Make an adjustment using the
DRYNESS function (see chap-
ter ”Drying”)
Conductance of water at installa-
tion site differs from standard set-
ting of machine.
Re-programme standard setting for
degree of drying (see ‘Program-
ming options’ chapter).
When a button is pressed
- no reaction of the ma-
chine.
Drying protection. After the start of
the programme, the option can no
longer be set.
Turn the programme knob to OFF.
Set the programme again.
Drum light does not work.
Programme selector in OFF posi-
tion.
Turn programme selector to any
programme.
Defective light bulb.
Replace light bulb (see next sec-
tion).
Displayed programme
time changes erratically or
stays unchanged for a
long time.
Programme time is corrected auto-
matically depending on type and
volume of laundry and level of
dampness.
Automatic process; this is not a
machine fault.
electrolux 21