Electrolux 86741 Washer User Manual


 
Operating Instructions
33
Washing machine vi-
brates during operation
or is unstable.
Transport packaging has not
been removed.
Remove transport packaging
according to setting up and
connection instructions.
The machine is not level.
Adjust the feet according to
installation and connection
instructions.
There is very little washing in
the drum (e.g. only a dressing
gown).
This does not affect the op-
eration of the machine.
Water could not be fully
pumped out before spinning
because the drain hose is
kinked or water pump is
blocked.
Check the drain hose and re-
move any kink if necessary,
or clean the drain pump and,
if necessary, remove foreign
bodies from the pump hous-
ing.
Excessive foaming dur-
ing the main wash.
Probably too much detergent
has been used.
If may be necessary to re-
duce the amount of deter-
gent used. Follow the
detergent manufacturer’s
recommendations.
Water leaks out of the
washing machine.
The screw Connection on the
inlet hose is leaking.
Tighten the inlet hose screw
connection.
Drainage hose is leaking.
Check the drain hose and re-
place it if necessary.
The drain pump cover is not
correctly close.
Close cover correctly.
Washing is caught in the
door.
Stop the programme, remove
the washing caught in the
door. Restart the programme.
The emergency emptying
hose is not correctly closed
or is leaking.
Close the emergency empty-
ing hose (see section „Carry
out emergency emptying“).
Call your local Service Force
Centre if the emergency
emptying hose is leaking.
Problem Possible cause Remedy