Filter
Top Products
Any fabric softener or starching additives must be poured into the compartment
marked before starting the wash programme.
Follow the product manufacturers’ recommendations on quantities to use and do
not exceed the «MAX» mark in the detergent dispenser drawer.
Quantity of detergent to be used
The type and quantity of detergent will depend on the type of fabric, load size,
degree of soiling and hardness of the water used.
Follow the product manufacturers’ instructions on quantities to use.
Use less detergent if:
• you are washing a small load,
• the laundry is lightly soiled,
• large amounts of foam form during washing.
• For the stain treatment before the washing cycle, follow the product
manufacturers’ instructions on detergent quantities. If you use any specific
product to remove the stains, you must start the washing immediately .
Degrees of water hardness
Water hardness is classified in so-called “degrees” of hardness. Information on
hardness of the water in your area can be obtained from the relevant water
supply company, or from your local authority.
Note: A water softener must be added when water has a medium-high degree
of hardness (from degree of hardness II). Follow the manufacturer’s instructions.
The quantity of detergent can then always be adjusted to degree of hardness I (=
soft).
29
Preparing the wash cycle
LLeevveell
1
Characteristic
soft
DDeeggrreeeess ooff wwaatteerr hhaarrddnneessss
GGeerrmmaann
°°ddHH
FFrreenncchh
°°TT..HH..
0-7 0-15
2 medium
8-14 16-25
3 hard
15-21 26-37
4 very hard
> 21 > 37
132963810_EN.qxd 06/06/2008 11.46 Pagina 29