Filter
Top Products
The display shows the following information:
Duration of the selected programme
After selecting a programme, the duration is displayed in hours and minutes (for
example
2.05). The duration is calculated automatically on the basis of the
maximum recommended load for each type of fabric.
After the programme has started, the time remaining is updated every minute.
Delay start
The selected delay (20 hours max) set by means of the relevant button appears
on the display for about 3 seconds (for example
90’), then the duration of the
previously selected programme is displayed.
The DELAY START symbol will appear on the display.
The delay time value decreases by one unit every hour and then, when 1 hour
remains, the time decreases every minute.
Incorrect option selection
If an option which is not compatible with the set wash programme is selected,
the message Err is displayed for about 2 seconds and the yellow light of button
7 starts blinking.
Alarm codes
In the event of operating problems, some alarm codes can be displayed, for
example
E20 (see chapter «What to do if...»).
End of the programme
When the programme has finished a blinking zero 0 is displayed, the DOOR
symbol disappears and the door can be opened.
If your laundry is not removed within 10 minutes after the programme is finished,
the backlight of the display switches off and the energy saving system will be
enabled.
Only the button
7 pilot light is blinking to indicate that the appliance has to be
switched off.
By pressing any button the appliance will come out from the energy saving status
and you could set another washing programme or switch off the appliance.
DELAY START - symbol
CHILD SAFETY LOCK - symbol
12
Display
9.8
9.9
9.7
132963810_EN.qxd 06/06/2008 11.46 Pagina 12