Filter
Top Products
29
If after these checks, the tumble dryer still does not work, contact your
local AEG Service Force Centre.
Please note that it will be necessary to provide proof of purchase for
any in-guarantee service calls.
In-guarantee customers should ensure that the above checks have been
made as the engineer will make a charge if the fault is not a mechani-
cal or electrical breakdown.
Replace the interior light
0 A replacement bulb can be purchased through your local AEG Service
Force Centre (Part No: 647072580).
1
Warning! Never use standard light bulbs in your Lavatherm.
0 Isolate the appliance from the mains supply.
0 Screw-off the bulb cover. (The bulb is located at the top behind the
door; see Front view).
0 Replace the defective bulb.
0 Screw-on the bulb cover.
1
Warning! For safety reasons the bulb cover must be screwed-on. The
dryer must not be operated, without the cover in place.
The remaining PROG. TIME
display changes rapidly.
The remaining running
time is adjusted
automatically depending
on the type of items
being washed, the
washing time and the
degree of dampness
Automatic process. There
is no unit fault.
The drying process takes
unusually long. 4.5 hours
after the beginning of the
drying process:
- END display flashes
- acoustic signal sounds
- discontinuation of the
drying process
- error code C6 is displayed
SPECIAL CARE button
pressed and too much
laundry filled-in
Check the program
selection: SPECIAL CARE
button appropriate only
for laundry amounts up
to 2.5kg
Too much laundry
filled-in
Reduce the amount of
laundry filled-in
Laundry too damp
Pre-dry the laundry more
thoroughly
Symptom Possible cause Solution