Filter
Top Products
Programming possibilities
25
Programming possibilities
The electronic control system of your laundry dryer provides you with
the possibility to adapt some functions of the dryer permanently to
your requirements.
Purpose Execution
"Laundry protection": If
you want to "lock" the
selected drying program
(the selected program
setting cannot be
changed during the
drying process at the
program selector or with
the SPECIAL CARE or
QUICK button):
When "Washing
Protection" is enabled,
the drying programme
always runs at reduced
heater power (SPECIAL
CARE Function).
When a drying program is set at the program selector and
the START button has been pressed:
- Hold the SPECIAL CARE button depressed for five
seconds.
The program execution display flashes for five seconds and
the laundry protection is then switched-on.
If an attempt is nevertheless made to change the program
setting, the program execution display flashes; after
pressing the SPECIAL CARE or QUICK button, it flashes for
five seconds; on turning the program selector it flashes
until the program selector is returned to the initial setting.
To cancel the laundry protection:
- Hold the SPECIAL CARE button depressed for five
seconds.
The program run indicator flashes for five seconds, then it
is lit steady for five seconds; laundry protection is
cancelled.
If you always want to be
reminded by an audible
signal at the end of the
program:
1) Ensure that the program selector is not in the setting
LIGHT or OFF.
2) Hold the AUDIBLE SIGNAL button depressed for at least
five seconds.
The AUDIBLE SIGNAL display lights; a short audible signal is
sounded.
The selected setting is therewith fixed-programmed.
If you want to cancel this setting:
3) Proceed as described under item 1) and 2).
The display AUDIBLE SIGNAL disappears.
If you remove
condensate via an
external condensate
drain-off and wish to
permanently suppress
the EMPTY WATER
indication:
1) Set the programme selector to LIGHT.
2) Hold the AUDIBLE SIGNAL button depressed for five
seconds.
The PROG. TIME display shows U for normal function and &
for external condensate drain-off.
3) Briefly press the AUDIBLE SIGNAL button to choose
between U and & .
4) Turn the program selector.
The selected setting is therewith fixed-programmed.