Filter
Top Products
Something not working?
28
The drying result is unsatis-
factory; the washing is still
damp.
The water hardness in
your area does not corre-
spond to the standard
setting of the appliance.
Reprogram the standard
setting, eg. H0 instead of
H1, for dryer washing (see
chapter “Programming
Possibilities“.
The drum illumination does
not work
Is the tumble dryer
plugged in
Plug in the tumble dryer
The program selector is in
the OFF position
Turn the program selector
dial to LIGHT
The bulb needs replacing Replace bulb
The drying process takes
unusually long
The condenser unit is
covered with fluff
Clean the condenser unit
Fluff filter is clogged Clean the fluff filter
The fill-in door cannot be
opened with the DOOR button
Electric mains plug not
connected
Connect the mains plug
Program selector set to
OFF
Set a program. The fill-in
door can be opened at
any time by pressing
firmly against the door
(pressing location
)
The door cannot be closed
Fluff filter has not been
inserted correctly and/or
the filter lid not closed
Replace the fluff filter
and ensure the filter lid is
closed
Display EMPTY WATER is lit Condensate container full
Empty the condensate
container
EMPTY WATER indicator illu-
minated, even though the
container has already been
emptied
Foreign bodies, e. g. ani-
mal hairs, can block the
inlet nozzle as well as the
valve on the end of the
EMPTY WATER container
With the container pulled
out, switch on the
appliance momentarily.
The blockage can be
removed from the contai-
ner shaft or the hair clea-
ned out of the valve
The dryer terminates the
drying process automatically:
END is displayed shortly after
program start; no display of
the extent of drying
Too dry or too little
laundry filled-in for the
selected program
Select time program or
higher drying stage (e.g.
EXTRA DRY instead of
CUPBOARD DRY)
Symptom Possible cause Solution