Filter
Top Products
50
Installation
Unpacking
All transit bolts and packing must be removed before using the appliance.
Using the supplied
spanner, unscrew
and remove the 2
rear bottom
screws. Slide out
the 2 plastic pins.
Lay the machine
on its back, taking
care not to squash
the hoses. This can be avoided by placing one
of the corner packing pieces between the
machine and the floor.
Remove the polystyrene block from the
bottom of the machine and release the two
plastic bags.
Carefully slide out the left-hand bag
removing it towards the right and then
downwards.
Slide out the
right-hand bag
removing it
towards the left
and then upwards.
Set the machine
upright and
remove the
remaining rear
screw. Slide out
the relevant pin.
Plug the open
holes with the
plugs which you
will find in the
plastic bag con-
taining the instruction booklet.
You are advised to keep all transit devices so that they can be refitted if the
machine ever has to be transported again.
P1129
P1124
2
3
1
P1126
P1127
P0001
P1128
P0002
132984010.qxd 24/06/2005 16:30 Pagina 50