Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
AJ1032
10
NOTE: The following instructions will OPTIMIZE
garment quality and prolong padding life.
Pre-Operating Services
Perform the following services daily before using
press:
1. Check condition of buck padding. Padding
should be replaced if:
• Cover is scorched or torn.
• Cover is hard, brittle or not springy.
2. Open air supply line and downstream relief shut-
off valves. If press is equipped with a timer, close
electrical disconnect switch or circuit breakers.
3. Simultaneously push and hold both CLOSE
pushbuttons (Items 1 and 6, Figure 2) until head
is closed against buck.
4. Release CLOSE pushbuttons. Head should
remain closed.
5. Push OPEN pushbutton (Item 5, Figure 2). Head
should open.
6. Simultaneously push both CLOSE pushbuttons.
As head travels downward, release left
pushbutton. Head should return open.
7. Simultaneously push both CLOSE pushbuttons.
As head travels downward, release right
pushbutton. Head should return open.
8. Simultaneously push both CLOSE pushbuttons.
Have a second person press the OPEN
pushbutton as you continue pressing the CLOSE
pushbuttons. Head should open.
9. If pushbuttons do NOT perform as described in
steps 3 through 8, do NOT operate press. Call a
qualified service technician.
10. Slowly open steam supply and return shut-off
valves to prevent water hammer in steam pipes.
Allow 15 to 20 minutes for press to heat.
Press Operation
One complete pressing operation is described in the
following steps.
Presses WITHOUT Timers or Presses
WITH Timer Set to OFF Position
1. Perform pre-operating services.
2. If press is equipped with a timer, place switch
(Item 4, Figure 2) in OFF position.
3. Dress garment on buck.
4. Simultaneously push and hold both CLOSE
pushbuttons (Items 1 and 6, Figure 2) until head
closes and pressing pressure is applied. Release
both pushbuttons.
NOTE: If either pushbutton is released BEFORE
pressing pressure is applied, head will return to a
fully OPEN position.
5. Once garment is sufficiently pressed, press
OPEN pushbutton (Item 5, Figure 2) to open
press.
6. Hang or fold pressed article as soon as possible to
preserve finish.
Presses With Timers ONLY
1. Perform pre-operating services.
2. Place timer switch (Item 4, Figure 2) in the ON
position.
3. Set time selector knob (Item 2, Figure 2) to
desired time.
NOTE: Proper time required for pressing varies
with garment material and moisture retention. Set
timer so pressing pressure is applied long enough to
set a press. Proper time is best determined by
experience.
4. Dress garment on buck.
5. Simultaneously push and hold both CLOSE
pushbuttons (Items 1 and 6, Figure 2) until head
closes and pressing pressure is applied. Release
both pushbuttons.
To avoid possible serious injury when
cleaning or repairing traps or strainers:
• Shut off AND lock out ALL steam service
to press.
• Let heated surface cool.
W340
WARNING
To avoid possible serious injury:
• Perform steps 3 through 8 daily before
using press.
• Do NOT use press if ANY step is not
performing properly.
W341
WARNING