Beko WMI 71441 Washer User Manual


 
6
EN
2 Warnings
Please read the following information.
Otherwise, there may be the risk of
personal injury or material damage.
Moreover, any warranty and reliability
commitment will become void.
General Safety
Never place your machine on a
carpet covered floor. Otherwise,
lack of airflow from below of your
machine may cause electrical parts to
overheat. This may cause problems
with your washing machine.
If the power cable or mains plug is
damaged you must call Authorized
Service for repair.
Check water hoses for wear. Do not
use old/used water inlet hoses. These
may cause stains on your laundry.
Fit the drain hose into the discharge
housing securely to prevent any water
leakage and to allow machine to take
in and discharge water as required.
It is very important that the water
intake and drain hoses are not folded,
squeezed, or broken when the
appliance is pushed into place after it
is installed or cleaned.
Your washing machine is designed to
continue operating in the event of a
power interruption. You cannot cancel
any program by pressing the “On/Off
button.” Your machine will not resume
its program when the power restores.
Press the “Start/Pause/Cancel”
button for 3 seconds to cancel the
program (See, Cancelling a Program)
There may be some water in your
machine when you receive it. This is
from the quality control process and
is normal. It is not harmful to your
machine.
Some problems you may encounter
may be caused by the software.
Press “Start/Pause/Cancel” button
for 3 seconds to cancel the program
set in your machine before calling the
authorized service.
First Use
To prepare your machine for washing,
carry out your first washing process
without loading your machine and
with detergent under “Cottons 90°C”
program.
Ensure that the cold and hot water
connections has been made correctly
when installing your machine.
Otherwise, your laundry may come
out hot at the end of the washing
process and may wear out.
If the current fuse or circuit breaker is
less than 16 Amperes, please have
a qualified electrician install a 16
Ampere fuse or circuit breaker.
While using with or without a
transformer, do not neglect to have
the grounding installation laid by a
qualified electrician. Our company
shall not be liable for any damages
that may arise when the machine is
used on a line without grounding.
To make your machine ready for use,
please be sure that the tap water
supply and water drainage systems
are appropriate before calling the
authorized service. If they are not,
call a qualified plumber to have any
necessary arrangements carried out.
Intended use
This product has been designed for
home use.
The appliance may only be used for
washing and rinsing of textiles that
are marked accordingly.
Only detergents, softeners and
supplements suitable for washing
machines may be used.
Observe the care instructions labelled
on textile products and any other
instructions given by companies that
produce detergents for your machine.
This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction