Filter
Top Products
21
EN
C
Use a lower spin speed for delicate
laundry.
Temperature selection
Whenever a new program is selected, the
temperature anticipated for that program
appears on the temperature indicator .
To change the temperature, press
the temperature button. Temperature
decreases in 10° increments.
Cold selection is shown with “-” symbol.
When the “Temperature” button is
pressed after Cold is selected, the
maximum temperature of the program
you have selected will be displayed.
To decrease the temperature, press the
“Temperature” button again.
90˚C
Normally soiled, white cottons
and linens. (Ex.: coffee table
covers, tablecloths, towels, bed
sheets)
60˚C
Normally soiled, fade proof
coloured linens, cottons or
synthetic clothes (Ex.: shirts,
nightgowns, pyjamas) and
lightly soiled white linen clothes
(Ex.: underwear)
40˚C
30˚C
Cold
Blended clothes including
synthetics and woollens as well
as delicates.
Economy Symbol
Shows energy saving programs and
temperature selections.
As “Intensive” and “Hygiene” programs
are long programs with higher
temperature selections to ensure hygiene,
“Economy” Symbol will not light up.
Spin Speed selection
Whenever a new program is selected,
the maximum spin speed of the selected
program is displayed on the spin speed
indicator.
To decrease the spin speed, press the
“Spin” button. Spin speed decreases
gradually. Then, rinse hold and no spin
options are shown respectively.
Rinse hold is shown with “ ” and no
spin is shown with “ ” symbols.
F2
F4
F1
F3
If you are not going to unload your
clothes immediately after the cycle, you
may use rinse hold function in order to
prevent your clothes becoming creased
when there is no water in the machine.
With this function, your laundry is kept in
the final rinsing water. If you want to spin
your laundry after the rinse hold function:
- Adjust the spin speed.
- Press “Start/Pause/Cancel” button.
Program resumes. Your machine
drains the water and spins your
laundry.
You can use no spin function in order to
drain the water without spinning at the
end of the program.