Filter
Top Products
29
EN
• Close the taps.
• Remove the nuts of the water intake
hoses to clean the surfaces of the
filters on the water intake valves with an
appropriate brush.
• If the filters are very dirty, you can pull
them out by means of pliers and clean
them.
• Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly under
streaming water.
• Replace the gaskets and filters carefully
to their places and tighten the hose
nuts by hand.
Draining any remaining water
and cleaning the pump filter
Filter system in your machine prevents solid
items such as buttons, coins and fabric
fibers clogging the pump propeller during
discharging of the washing water. Thus, a
good water discharger is achieved and the
pump life is extended.
• If your machine fails to drain the water,
the pump filter may be clogged. You
may have to clean it every 2 years or
whenever it is plugged. Water must be
drained off to clean the pump filter.
In addition, water may have to be drained
off completely in the following cases:
• before transporting the machine (e.g.
when moving house)
• when there is the danger of frost
In order to clean the dirty filter and
discharge the water;
1- Unplug the machine to cut off the supply
power.
A
There may be water at 90°C in the
machine. the filter must be cleaned only
after the inside water is cooled down to
avoid hazard of scalding.
2- Open the filter cap. The filter cap may be
composed of one or two pieces according
to the model of your machine.
If it is composed of two pieces, press the
tab on the filter cap downwards and pull the
piece out towards yourself.
C
If your machine is built-in, then it does
not contain a filter cover.
If it is composed of one piece, hold it from
both sides and open it by pulling out.
C
You can remove the filter cover
by slightly pushing the kick plate
downwards with a screwdriver, through
the gap above the filter cover.
3- An emergency drain hose is supplied
with some of our models. Others are not
supplied with this item.
If your product is supplied with an
emergency drain hose, do the following as
shown in the figure below:
• Pull out the pump outlet hose from its
housing.