Filter
Top Products
27 EN
Problem Cause Explanation / Suggestion
Program
cannot be
started or
selected.
Machinemayhave
switched to self
protection mode due to
an infrastructure problem
(suchaslinevoltage,water
pressure,etc.).
Resetyourmachinebypressing“Start/Pause/
Cancel”buttonfor3seconds.(see,Cancellinga
Program)
Water in the
machine.
There may be some water
in your machine when you
receive it. This is from the
quality control process and
is normal.
It is not harmful to your machine.
There is water
coming from
the bottom of
the machine.
There might be problems
with hoses or the pump
filter.
Be sure the seals of the water inlet hoses are
securely fitted.
Tightly attach the drain hose to the waste pipe or
sink.
Makesurethatthepumpfilteriscompletely
closed.
Machinedoes
not fill with
water.
Tap may be turned off. Opentheinletwatertapsfully.
Water inlet hose might be
bent.
Straighten the water intake hose.
Water inlet filter might be
clogged.
Clean the water intake filter.
The door may be ajar. Close the door.
Machinedoes
not discharge
water.
Water outlet hose might be
clogged or twisted.
Clean or straighten the hose.
Pumpfiltermaybe
clogged.
Clean the pump filter.
Machine
vibrates or
shakes.
Machinefeetmightrequire
adjustment.
Adjust the machine feet.
Transportation safety
bolts might have not been
removed.
Remove the transportation safety bolts.
There may be a small
amount of laundry in the
machine.
Add more laundry to the machine.
The machine may be
overloaded or the clothes
may be distributed
unevenly.
Reduce the amount of laundry in the machine or
balance the load by hand.
There machine might be
touching a solid surface
Ensure that nothing touches the machine.
Machine
stopped
shortly after
the program
started.
Machinecanstop
temporarily due to low
voltage.
It will resume operating when the voltage is back
to the normal level.
The water
being taken
in is directly
discharged.
Improper position of the
drain hose.
Connect the water draining hose as described in
the operation manual.
8 Troubleshooting