Beko WMC61W Washer User Manual


  Open as PDF
of 36
 
22 EN
Preparation
1. Turn the tap on completely. Check if
the hoses are connected tightly.
2.Placethelaundryinthemachine.
3. Add detergent and softener.
Starting
1.Pressthe“On/Off”button.
2. Select the programme and the
temperature.
3.Ifrequired(accordingtoyour
machine’smodel):
– selectanyauxiliaryfunction,
– adjustthespinspeed,
– setthetimedelay,
4. Close the loading door.
5.PressStart/Pause/Cancelbutton.
Canceling a program
• Press“Start/Pause/Cancel”button
for 3 seconds. The machine starts
todischargethewater.“Wash”and
“ProgramFinished”lightswilllightup.
• “Start/Pause/Cancel”and“Wash”
lights will go off after discharging
processisoverandthe“Lid”lightwill
start flashing.
• Iftheprogramiscancelledinthe
middleoftheprocess,“Wash”and
“ProgramFinished”lightswilllight
up. The machine can drain all the
water or can take in water for 3 times
at most to cool down the clothes
and complete draining process.
When water discharging process is
completed,“Wash”lightwillgooff,
“ProgramFinished”lightwilllightup
andthe“Lid”lightwillcontinuously
flash until the door is allowed to
beopened.Youcanmakeanew
programselectionwhenthe“Lid”light
is lit continuously.
Adding more laundry
Youmayaddmorelaundryintothe
machine at the beginning of washing.
C
Machineallowsaddingmorelaundry
during a later step only if the water
level is low enough to open the
loading door or if the temperature in
the machine is low enough.
In order to add laundry after the start-up
oftheprogram:
1.PressStart/Pause/Cancelbutton.
Wait until the door is allowed to open.
“Lid”lampwilllightupcontinuously
when the door is allowed to open.
2.Opentheloadingdoorandputin
more laundry.
3. Close the loading door.
4.PressStart/Pause/Cancelbutton.
Program is in rinse hold mode
C
After the machine fills with water in
the final rinse step, clothes can be
soaked in the machine as long as
desired.
When it reaches this position while the
machineisrunning,the“Start/Pause/
Cancel”lightwillflash.
In the machines equipped with spin
speed selection knob, you can spin by
selecting the desired spin speed and
press“Start/Pause/Cancel”button.
As for machines not equipped with a
spin speed selection knob, you can
end the program without spinning by
pressingthe“Start/Pause/Cancel”
buttontodrainthewater.Youmayspin
your clothes whenever you wish to by
selecting the spin program.
Re-spinning the laundry
The control system for an unbalanced
load can pause the spinning in cases
when the distribution of the laundry in
the drum is not balanced.
Ifyouwanttore-spintheclothes:
1. Rearrange the previously placed
clothes in machine.
2.SelectSpin+Pumpprogram.
3. Set the spin speed if spin speed
adjustment is available on your
machine.
4.Press“Start/Pause/Cancel”button.
After the program is finished
1.“Programfinished”lampwilllightup
on the program follow-up indicator.
6 Quick instructions for daily use
 previous next