Beko WMC61W Washer User Manual


 
10 EN
Connecting to the water
supply.
Important:
•Thewatersupplypressurerequired
to run the machine must be 1-10
bar(0,1–1MPa).(Practically,itis
necessarytohave10–80liters
of water flowing from the tap in
one minute to have your machine
runsmoothly.)Attachapressure-
reducing valve if the water pressure is
higher.
•Connectthespecialhosesupplied
with the machine to the water intake
valves on the machine.
• Inordertopreventwaterleakagethat
may occur at the connection points,
therearerubberseals(4sealsforthe
models with double water inlet and
2sealsforothermodels)attached
to the hoses. These seals should
be used at the tap and machine
connection ends of the hoses. The
plain end of the hose fitted with a filter
must be attached to the tap and the
elbowed end must be attached to the
machine. Tighten the nuts of the hose
wellbyhand;neverusewrenchesto
tighten the nuts.
• Openthetapscompletelyafter
making the hose connection to check
if there is any water leakage at the
connection points. Turn off the tap
and remove the nut in case of any
leakage. Retighten the nut carefully
after checking the seal. To prevent
any water leakage and any other
damage to be caused by it, keep the
taps closed when the machine is not
in use.
• Modelswithasinglewaterinlet
should not be connected to the hot
water tap. Laundry may be damaged
or the appliance may switch to
protection mode and not work.
When returning the appliance to its
place after maintenance or cleaning,
care should be taken not to fold,
squeeze or block the hoses.
Connecting to the drain
The water discharge hose can be
attached to the edge of a washbasin
or waste water system. The drain hose
should be firmly fitted into the drain as
to not loosen in its housing.
Important:
• Theendofthedrainhosecanbe
directly connected to the wastewater
drain or to the washbasin. The
fitting must be secured in all types
ofconnections.Yourhousemay
be flooded if the hose falls out of its
housing during water discharging.
• Thehoseshouldbeattachedtoa
height of at least 40 cm, and 100 cm
at most.
• Incasethehoseiselevated
after laying it on the floor level or
closetotheground(lessthan
40cmabovetheground),water
discharge becomes more difficult
and the laundry may come out wet.
Therefore, the heights described in
the figure should be followed.
• Topreventdirtywaterrefillingthe