Beko WMB 91242DLSC Washer User Manual


  Open as PDF
of 32
 
EN
8
3
Installation
Removing packaging
reinforcement
Tilt the machine to remove the packaging
reinforcement. Remove the packaging
reinforcement by pulling the ribbon.
Opening the transportation
locks
C
Transportation safety bolts must be
removed before operating the washing
machine!Otherwise,themachinewill
be damaged!
1. Loosen all the bolts with a spanner
untiltheyrotatefreely(“C”)
2. Remove transportation safety bolts by
turning them gently.
3. Fitthecovers(suppliedinthebagwith
theOperationManual)intotheholes
ontherearpanel.(“P”)
C
Keepthetransportationsafetybolts
in a safe place to reuse when the
washing machine needs to be moved
again in the future.
C
Never move the appliance without the
transportation safety bolts properly
fixed in place!
Appropriate installation location
Install the appliance in environments which
have no risk of freezing, in a stable and
level position.
C
The floor must be capable of carrying
the load on it!
C
If the washing machine and a drier
are placed on top of each other, their
approximate weight together may
reach 180 kg when they are full.
Important:
• Donotplacetheapplianceontopof
the power cable.
• Keepatleast1cmdistancefromthe
edges of other furniture.
• Placethemachineonafirmsurface;
do not position it on a long pile rug or
such like surfaces.
Adjusting the feet
C
Do not use any tools to loosen the
locknuts.Otherwise,theycanbe
damaged.
1. Manually(byhand)loosenthelock
nuts on the feet.
2. Adjust them until the machine stands
level and firm.
3. Important:Tightenalllocknutsup
again.
Connecting to the water supply.
Important:
• Thewatersupplypressurerequired
to run the machine must be 1-10 bar
(0,1–1,0MPa).Attachapressure-
reducing valve if the water pressure is
 previous next