Beko WMB 91242DLSC Washer User Manual


  Open as PDF
of 32
 
EN
25
under streaming water.
• Replacethegasketsandfilters
carefully and tighten the hose nuts by
hand.
Draining any remaining water
and cleaning the pump filter
Filter system in your machine prevents
solid items such as buttons, coins and
fabric fibers clogging the pump propeller
during discharging of the washing water.
Thus, a good water discharge is achieved
and the pump life is extended.
• Ifyourmachinefailstodrainthewater,
thepumpfiltermaybeclogged.You
may have to clean it every 2 years or
whenever it is blocked plugged. Water
must be drained off to clean the pump
filter.
In addition, water may have to be drained
offcompletelyinthefollowingcases:
• beforetransportingthemachine(e.g.
whenmovinghouse)
• whenthereisthedangeroffrost
In order to clean the dirty filter and
dischargethewater;
1- Disconnect or unplug the machine from
the power supply.
A
There may be water at 90°C in the
machine. Therefore, the filter must be
cleaned only after the inside water
is cooled down to avoid hazard of
scalding.
2-Openthefiltercap.Thefiltercap
may be composed of one or two pieces
according to the model of your machine.
If it is composed of two pieces, press the
tab on the filter cap downwards and pull
the piece out towards yourself.
If it is composed of one piece, hold it from
both sides and open it by pulling out.
C
Youcanremovethefiltercover
by slightly pushing the kick plate
downwards with a screwdriver,
through the gap above the filter cover.
3- An emergency drain hose is supplied
withsomeofourmodels.Othersarenot
supplied with this item.
If your product is supplied with an
emergency drain hose, do the following as
showninthefigurebelow:
• Pulloutthepumpoutlethosefromits
housing.
• Placealargecontainerattheendof
the hose. Drain the water off into the
container by pulling out the plug at
the end of the hose. If the amount of
water to be drained off is greater than
the volume of the container, replace
the plug, pour the water out, then
resume the draining process.
• Afterdrainingprocessiscompleted,
replace the plug into the end of the
hose and fit the hose back into its
place.
If your product is not supplied with an
emergency drain hose, do the following as
showninthefigurebelow:
 previous next