Beko BWD 6421 Washer User Manual


 
EN
20
If you detect any problems with your
washing machine, you will probably
be able to rectify them yourself by
consulting the following instructions.
Important
If this is not the case, unplug the
appliance and contact the TECHNICAL
ASSISTANCE SERVICE.
C
Never open up the appliance. There
is no fuse or similar component
inside that can be replaced by the
user.
7 Safety and troubleshooting
Indicator Problems
FO1 No water coming in
FO2 Does not drain or spin-dry
CO3 Does not spin-dry
FO4 Does not start
FO5
.
.
F10
Call the Technical
Assistance Service
Why won’t the washing machine start?
Check the door is properly shut.
The washing machine is not plugged into the mains or there is no voltage in
the mains supply.
The Start/Stop button has not been pressed.
If the washing machine door is not properly shut, F04 will appear on the
display.
Why is the washing machine vibrating or making too much noise?
The blocking and transport screws have not been removed.
The washing machine has not been correctly levelled.
Why doesn’t the washing machine take in water?
Indicator F01, no water coming in, this may be due to a cut in the water
supply, a tap turned off or a blocked water inlet filter.
The possible solutions are as follows: wait for the water supply to be
reconnected, turn on the tap, or remove the water inlet hose and clean the
filter.
If this failure is detected, F01 will appear on the display.
Why doesn’t the washing machine drain or spin-dry?
The reasons for the F02 indicator may be the following: washing machine drain
pump blocked, building drainage pipes blocked, or incorrect pump electrical
connection.
Solution: if the pump is blocked, gain access to it as described in section 2,
maintaining and cleaning the appliance.
If this failure is detected, F02 will appear on the display.