Filter
Top Products
26
b. Microprocessor (computer) Dryer Models
1. Spin and stop times are not adjustable in the Automatic Mode and have been preprogrammed into
the microprocessor controller (computer) for 120 seconds spin time and a 5 second dwell (stop) time.
2. Spin and stop times are adjustable in the Manual (timed) Mode.
J. OPERATING INSTRUCTIONS
NOTE: Before attempting to start the dryer make sure the main door is closed and the lint drawer is
securely in place.
1. To start the dryer:
a. Microprocessor (computer) Dryers
1. Display will read "READY" (no cycle in progress).
2. Press the letter on the keyboard (touchpad) corresponding to the cycle desired (i.e., Key "E"). Dryer
will start to rotate.
3. L.E.D. (light emitting diode) display will now toggle "Drying" "Manual" "Cycle E" "30 Min" "Remain"
meaning the dryer is in the drying cycle and count down in minutes.
NOTE: Pressing touch pad key "A," "B," "C," "D," and "F" will also start the dryer. The six (6)
preprogrammed drying cycles ("A" through "F") have been stored in the microprocessor
(computer's) memory. Refer to the Computer Programming Manual supplied with dryer for
more specific operating information.
NOTE: The dryer can be stopped at any time by opening main door or by pressing the "STOP" key.
The restart the dryer, press the "START" key or preprogrammed cycle key (i.e., "E").
NOTE: Selection (setting) changes can be made at any time during the drying cycle by pressing the
"CLEAR/STOP" key twice. The L.E.D. display will return to "READY" at which time a new
cycle selection can be made.
K. SHUT DOWN INSTRUCTIONS
If the dryer is to be shut down (taken out of service) for a period of time, the following must be performed:
1. Discontinue power to the dryer either at the external disconnect switch or the circuit breaker.
2. Discontinue the gas supply:
a. SHUT OFF external gas supply shut-off valve.
b. SHUT OFF internal gas supply shut-off valve located in the gas valve train area.