Filter
Top Products
113335-12 www.amdry.com 3
IMPORTANT
You must disconnect and lockout the electric supply
and the gas supply or the steam supply before any
covers or guards are removed from the machine
to allow access for cleaning, adjusting, installation,
or testing of any equipment per OSHA standards.
Please observe all safety precautions displayed on
the equipment and/or specified in the installation
manual included with the dryer.
Dryer must be installed in a location/environment,
which the ambient temperature remains between
40° F (4.44° C) and 130° F (54.44° C).
“Caution: Label all wires prior to disconnection
when servicing controls. Wiring errors can
cause improper operation.”
«Attention: Au moment de l’entretien des
commandes, étiquetez tous les fils avant de les
débrancher. Des erreurs de câblage peuvent
entraîner un fonctionnement inadéquat et
dangereux.»
CAUTION
Dryers should never be left unattended while in
operation.
WARNING
Children should not be allowed to play on or near
the dryer(s).
Children should be supervised if near dryers in
operation.
Under no circumstances should the dryer door
switch, lint drawer switch, heat safety circuits ever
be disabled.
The dryer must never be operated with any of the
back guards, outer tops, or service panels
removed. Personal injury or fire could result.
Dryer must never be operated without the lint filter/
screen in place, even if an external lint collection
system is used.
FOR YOUR SAFETY
Do not dry mop heads in the dryer. Do not use
dryer in the presence of dry cleaning fumes.
Dryer must not be installed or stored in an area
where it will be exposed to water or weather.
The wiring diagram for the dryer is located in the
front electrical control box area.
List of Acronyms _____________________
D.M.S. Drill Measurement Size
DSI Direct Spark Ignition
F.S.S. Fire Suppression System
HSI Hot Surface Ignition
HVAC Heating, Ventilating, and Air-Conditioning
in wc Inches of Water Column
L.E.D. Light Emitting Diode
L.P. Liquid Propane
OSHA Occupational Safety and Health Administration
R.M.A. Return Material Authorization
Table of Contents ________
Safety Precautions ..............................................4
ML-130 Specifications ........................................6
ML-130DR Specifications ....................................8
Installation Procedures .....................................10
Location Requirements............................................ 10
Unpacking/Setting Up............................................... 10
Dryer Enclosure Requirements ................................ 11
Fresh Air Supply Requirements ............................... 12
Exhaust Requirements ............................................ 12
Electrical Information ................................................ 14
Gas Information ........................................................ 16
Steam Information .................................................... 18
Preparation for Operation ......................................... 20
Preoperational Test .................................................. 20
Shutdown Instructions.............................................. 21
Operating Instructions .............................................. 21
Service/Parts Information ................................22
Service....................................................................... 22
Parts .......................................................................... 22
Warranty Information ........................................22
Returning Warranty Cards ........................................ 22
Warranty .................................................................... 22
Returning Warranty Parts ......................................... 22
Routine Maintenance ........................................23
Cleaning.................................................................... 23
Adjustments .............................................................. 24
Lubrication ................................................................ 24
Data Label Information .....................................24
Reversing Timer Spin/Dwell Adjustments ........24
Procedure for Functional Check
of Replacement Components ...........................25
Manual Reset Burner Hi-Limit Instructions ......26
Phase 7 ..................................................................... 26
Dual Timer ................................................................ 26
Fire Suppression System ..................................26
Proposition 65
Use of this product could expose you to substances
from fuel combustion that contain chemicals
known to the State of California to cause cancer,
birth defects and other reproductive harm.
▲ WARNING
!