Filter
Top Products
24 American Dryer Corp. 113335-12
NOTE: A back draft damper that is sticking partially closed
can result in slow drying and shutdown of the heat circuit
safety switches or thermostats.
When cleaning dryer cabinet(s), avoid using harsh
abrasives. A product intended for the cleaning of
appliances is recommended.
Adjustments
7 Days After Installation
and Every 6 Months Thereafter
Inspect bolts, nuts, screws, setscrews, grounding
connections, and nonpermanent gas connections (unions,
shutoff valves, and orifices). Motor and drive belts should be
examined. Cracked or seriously frayed belts should be
replaced. Tighten loose V-belts when necessary. Complete
operational check of controls and valves. Complete
operational check of all safety devices (door switch, lint drawer
switch, sail switch, and hi-limit thermostats).
Lubrication
The motor bearings and under normal/most conditions the
tumbler and idler bearings are permanently lubricated. It is
physically possible to relubricate the tumbler and idler
bearings if you choose to do so even though this practice is
not necessary. Use Shell Alvania #2 or its equivalent. The
tumbler and idler bearings used in the dryer do not have a
grease fitting. Provisions are made in the bearing housing
for the addition of a grease fitting, which can be obtained
elsewhere, or from ADC by ordering kit Part No. 882159
(tumbler ONLY), which includes 2 fittings.
Data Label Information _______________
When contacting American Dryer Corporation, certain
information is required to ensure proper service/parts
information from ADC. This information is on the data label
located on the left side panel/wall area behind the control
door. When contacting ADC, please have the model number
and serial number available.
1. Model Number – Describes the size of the dryer and
the type of heat (gas, electric, or steam).
2. Serial Number – Allows the manufacturer to gather
information on your particular dryer.
3. Manufacturing Code Number – The number issued
by the manufacturer, which describes all possible options
on your particular model.
4. Type of Heat – This describes the type of heat for your
particular dryer, gas (either natural gas or L.P. gas),
electric, or steam.
5. Heat Input (for Gas Dryers) – This describes the heat
input in British thermal units per hour (Btu/hr).
6. Orifice Size (for Gas Dryers) – Gives the number drill
size used.
7. Electric Service – This describes the electric service
for your particular model.
8. Gas Manifold Pressure (for Gas Dryers) – This
describes the manifold pressure taken at the gas valve
tap.
Reversing Timer
Spin/Dwell Adjustments ______________
Timer models have an electric reversing timer in the electric
service box, which is located in the upper left rear area of the
dryer.
Both the dwell (stop) time and tumbler spin time are adjustable
by mode selection switches located on the electronic timer
(as noted in the illustration below).
TIMING LEGEND
SPIN TIME
Adjustment Position Number12345
Time in Seconds* 30 60 90 120 150
DWELL (STOP) TIME
Adjustment Position Number12345
Time in Seconds* 5 6.3 7.6 8.9 10.2
* Values shown are +/- 1-second.