Filter
Top Products
450261-2 www.amdry.com 13
Belt Installation
Remove the back guard, front upper panel, and front lower panel. Cut the locking end off the plastic wire tie
and use a piece of electrical tape to secure the wire tie to one end of the 4-foot section of electrical wire
(Fig. 1).
Push the wire tie between the tumbler felt and the middle front panel ring at highest position of the tumbler
(Fig. 2). The wire tie must exit beyond the top of the tumbler (Fig. 3). Be careful NOT to damage the rotational
sensor. Take hold of the end of the wire tie, pull it and the electrical wire attached to it until 2 feet of wire
remains hanging inside the tumbler (Fig. 4). Attach the replacement belt to the end of the electrical wire still
hanging in the tumbler by making a loop in the wire and taping the loop closed with electrical tape (Fig. 5).
Squeeze the belt flat between your fingers (Fig. 6).
REQUIRED ITEMS:
4 feet of Number 16 or 18 Electrical Wire
Duct Tape
Phillips Screw Driver
5/16” Nut Driver
Electrical Tape
3 foot Section of 1-1/2” Electrical Tubing
One 6-inch Cable Tie
Replacement Belt
FIG. 1
FIG. 2 FIG. 3
FIG. 4
FIG. 5 FIG. 6