Filter
Top Products
34
2) Selection (setting) changes can be made at any time during the drying cycle by opening and closing
the main door and then making a new selection.
3) Additional time can be purchased at any time. If the dryer is in operation (drying mode) and
additional coins are inserted, the light emitting diode (L.E.D.) display will read the additional time
for amount inserted.
2.
Non-Coin (OPL) Dryers
The dryer is available for use when the L.E.D. display reads “FILL.” Once the load has been put into the
dryer and the main door is closed, start the dryer as follows:
a. Determine fabric setting (selection). Setting “HIGH TEMP” is the high-temperature range, the “PERM
PRESS” is the medium-temperature range, and the “LOW TEMP” setting is the low-temperature
range.
b. Once the fabric temperature setting (selection) has been determined, you start the dryer by pressing the
fabric setting key desired.
c. The dryer will now start, and the L.E.D. display for the basket (tumbler) selected will read the setting
(selection) and the drying portion of the L.E.D. display will read “00” and count upwards in time.
d. Upon completion of the drying cycle and cooling cycle, the dryer will shut off, the tone (buzzer) will
sound for 5-seconds, and the L.E.D. display will read “donE.”
NOTE: If the Anti-Wrinkle program is active, the L.E.D. display will remain reading “donE,” and the
microprocessor controller (computer) will proceed through the Anti-Wrinkle program until the
maximum “Active Guard Time” has expired or until the main door is opened, whichever comes
first.
NOTE: If the Anti-Wrinkle program is not active or in use, the L.E.D. display will read “donE” until
the main door is opened, at which time, the L.E.D. display will read “FILL.”
e. Notes
1) The dryer basket (tumbler) can be stopped at any time by opening the main door. To restart dryer,
shut the main door and press desired setting.
NOTE: When a cycle is interrupted by opening the main door, the cycle time will continue to count
upward, regardless if the door is open or closed until a keyboard (touch pad) selection is
made.
2) Selection (setting) changes can be made at any time during the drying cycle by opening and closing
the main door and then making a new selection.