Filter
Top Products
40
C. LUBRICATION
The motor bearings and under normal/most conditions the basket (tumbler) and idler bearings are permanently
lubricated. It is physically possible to re-lubricate the basket (tumbler) and idler bearings if you choose to do so
even though this practice is not necessary. Use Shell Alvania #2 or its equivalent. The basket (tumbler) and idler
bearings used in the dryer DO NOT have a grease fitting. Provisions are made in the bearing housing for the
addition of a grease fitting which can be obtained elsewhere, or from ADC by ordering kit Part No. 882159
(basket [tumbler] ONLY), which includes two (2) fittings.
D. LINT DRAWER REMOVAL
To remove the lint drawer from the dryer pull drawer out approximately half way. Rotate and move lint drawer
stop hinge (refer to the illustration below) downward and pull drawer out.
IMPORTANT: After reinstalling the lint drawer back into the dryer, be sure to rotate/move the hinge
back to the upward stop position.