Filter
Top Products
12
G. BLOWER MOTOR AND IMPELLOR
(NON-REVERSING)
(Viewing from the front of the dryer). The blower motor
is located on the back of the dryer at the lower right-hand
corner. The impellor is a backward curved paddle wheel
which is directly connected to the shaft of the blower
motor.
H. BLOWER MOTOR AND IMPELLOR
(REVERSING)
I. IDLER ASSEMBLY
(Viewing from the rear of the dryer). The idler assembly
is located approximately on the lower center of the dryer.
The idler assembly consists of two (2) idler pulleys, the
small and large pulleys. The idler’s main purpose is to
reduce the speed and increase torque provided to the
basket (tumbler) bearing. Also, at the idler assembly, belt
tension can be adjusted.
J. BASKET (TUMBLER) BEARING
AND PULLEY ARRANGEMENT
The basket (tumbler) bearing and pulley arrangement is
located (viewing from the rear of the dryer) approximately
at the upper center of the dryer. The arrangement consists
of a pulley and two (2) bearings which serve to drive,
adjust, and support the basket (tumbler).