Filter
Top Products
24
MONTHLY
Empty the compressed air filter bowl.
Apply high-temperature grease to the four (4) 2-3/16” diameter basket (tumbler) drive shaft pillow block bearings.
(Use Shell Alvania #2 grease or its equivalent.)
Retighten setscrews in the collars of the four (4) 2-3/16” diameter basket (tumbler) drive shaft bearings.
Clean any lint accumulation from the gas valve burner area at the right side of the dryer, the fan (impellor)
motor, and the fan (impellor) bearings located in the dryer base.
IMPORTANT: Clean ALL lint and debris that may have collected on the fan. Failure to do so
will cause premature component failure and will VOID THE WARRANTY.
Grease the two (2) fan (impellor) shaft bearings in the base of the dryer with Shell Alvania #2 grease or its
equivalent.
Check the fan (impellor) V-belts for tightness and wear. Retighten and/or replace if required.
Inspect and remove any lint accumulation in customer furnished exhaust ductwork system and from the dryer’s
internal exhaust ducting.
NOTE: THE ACCUMULATION OF LINT IN THE EXHAUST DUCTWORK CAN
CREATE A POTENTIAL FIRE HAZARD.
NOTE: DO NOT OBSTRUCT THE FLOW OF COMBUSTION AND VENTILATION AIR.
CHECK CUSTOMER FURNISHED BACK DRAFT DAMPERS IN THE EXHAUST
DUCTWORK. INSPECT AND REMOVE ANY LINT ACCUMULATION, WHICH
CAN CAUSE THE DAMPER TO BIND OR STICK.
NOTE: When cleaning the dryer cabinet(s), avoid using harsh abrasives. A product intended for
the cleaning of appliances is recommended.