Filter
Top Products
36
d. Once the preprogrammed dryness level and cool down period have been reached, or the maximum
automatic time has expired, the tone (buzzer) will sound for 5-seconds, and the L.E.D. (light emitting
diode) display will read "donE", at which time the dryer will shut off.
NOTES: 1. If the Anti-Wrinkle program is active, the L.E.D. (light emitting diode) display will continue
to read "donE", and the microprocessor controller (computer) will proceed through the
Anti-Wrinkle program until the maximum "Active Guard Time" has expired or until the door
is opened, whichever comes first. The L.E.D. display will read "FILL" and/or "Amount
to Start."
2. If the Anti-Wrinkle program is not active or in use, the L.E.D. display will read "FILL"
and/or "Amount to Start."
2. Timed Mode (Microprocessor [Computer] Models)
a. When turning on power or when no cycle is in progress, the L.E.D. (light emitting diode) display will read
"FILL" and/or "Amount to Start."
b. Insert Coin(s).
Once the correct "Amount to Start" has been inserted the L.E.D. (light emitting diode) display will read
"PUSH."
c. Select temperature by pushing "HI TEMP," "LO TEMP," or "PERM PRESS." The dryer will start, and
the L.E.D. (light emitting diode) display will read the temperature cycle selected and the drying time.
d. The dryer will continue through the drying and cooling cycles, showing time counting downward.
IMPORTANT: If the door is opened during a cycle, both the heat and motor will stop. However,
the microprocessor controller (computer) will continue to count down in time.
Continuation of the cycle will resume only after the door has been closed and any
other of the three (3) temperature selection buttons is again depressed.
e. Upon completion of drying and cooling cycles, the tone (buzzer) will sound for 5-seconds, and the L.E.D.
(light emitting diode) display will read "donE", at which time the dryer will shut off.
NOTES: 1. If the Anti-Wrinkle program is active, the L.E.D. (light emitting diode) display will continue
to read "donE", and the microprocessor controller (computer) will proceed through the
Anti-Wrinkle program until the maximum "Active Guard Time" has expired or until the door
is opened, whichever comes first. The L.E.D. display will read "FILL" and/or "Amount
to Start."
2. If the Anti-Wrinkle program is not active or in use, the L.E.D. display will read "FILL"
and/or "Amount to Start."
3. Free Dry Mode (Microprocessor [Computer] Models)
a. When turning on power or when no cycle is in progress, the L.E.D. (light emitting diode) display will read
"FILL" and/or "FrEE."