Filter
Top Products
113215-5 www.amdry.com 23
NOTE: To stop dryer, open main door or press the pause key. Continuation of the cycle will resume
only after the door has been closed and any of the three (3) temperature selection is pressed.
f. Upon completion of the drying and cooling cycles, the tone (buzzer) will sound and the dryer will go into
the Wrinkle Guard Mode for 99 minutes, or until the main door has been opened.
IMPORTANT: For more detailed information regarding the microprocessor controller (computer) on
your dryer, refer to the microprocessor user’s manual included with the dryer.
2. Free Mode
a. When the controller is in the ready state and no cycle is in progress, the L.C.D. screen will display
SELECT TEMPERATURE”.
b. Select temperature by pressing “HI”, “MED”, OR “LO”. The cycle will start and the controller will
display the Dry Cycle selected and the remaining time.
c. The dryer will continue through the drying and cooling cycles, until the drying time has expired.
d. In Free Mode, if more or less time is desired in a cycle press and hold either the “HI” or “LO” key for
3-seconds. The control will now display the remaining time in the cycle. Pressing the “HI” key will
increase the number of minutes remaining. Pressing the “LO” key will decrease the number of minutes
remaining. The dryer can be stopped by pressing the “PAUSE” key or opening the main door. Press
either “HI”, “MED”, or “LOW” key after pressing the “PAUSE” key or closing the main door to restart
the dryer.
3. Heat Circuit Operational Test
a. When a gas dryer is first started (during initial start-up), it has a tendency not to ignite on the first ignition
attempt. This is because the gas supply piping is filled with air, so it may take a few minutes for the air
to be purged from the lines.
NOTE: During the purging period, check to be sure that ALL gas shutoff valves are open.
NOTE: Gas dryers are equipped with a Direct Spark Ignition (DSI) system, which has internal
diagnostics. If ignition is not established after three (3) attempts, the heat circuit in the DSI
module will LOCKOUT until it is manually reset. To reset the DSI system, open and close the
main door and restart the dryer.
b. Once ignition is established, a gas pressure test should be taken at the gas valve pressure tap of each
dryer to ensure that the water column (W.C.) pressure is correct and consistent.
NOTE: Water column pressure requirements (measured at the pressure tap of the gas valve body):
Natural Gas ---------------------- 3.5 inches (8.7 mb) water column.
Liquid Propane (L.P.) Gas ----- 10.5 inches (26.1 mb) water column.