Filter
Top Products
22 American Dryer Corp. 113215-5
H. PREPARATION FOR OPERATION/START-UP
The following items should be checked before attempting to operate the dryer:
1. Read
ALL “CAUTION,” “WARNING,” and “DIRECTION” labels attached to the dryer.
2. Check incoming supply voltage to be sure that it is the same as indicated on the dryer data label. In the case
of 208 VAC OR 230/240 VAC THE SUPPLY VOLTAGE MUST MATCH THE ELECTRIC SERVICE
EXACTLY.
3. Check to ensure that the dryer is connected to the type of heat/gas indicated on the dryer data label.
4. The sail switch damper assemblies are installed and pre-adjusted at the factory prior to shipping. However,
each sail switch adjustment must be checked to ensure that this important safety control is functioning.
5. Be sure that ALL gas shutoff valves are in the open position.
6. Be sure
ALL back panels (guards) and electric box covers have been replaced.
7. Check
ALL service doors to ensure that they are closed and secured in place.
8. Be sure the lint drawers are securely in place.
9. Rotate the baskets/tumblers (both top and bottom) by hand to make sure they both move freely.
10. Check bolts, nuts, screws, terminals, and fittings for security.
11. Check basket (tumbler) bearing setscrews to ensure they are ALL tight.
I. PREOPERATIONAL INSTRUCTIONS
1. Coin Mode
a. When the microprocessor controller (computer) is in the ready state, the liquid crystal display (L.C.D.)
screen will display “READY, INSERT AMOUNT TO START” or “READY, INSERT $XX.XX TO
START”.
b. Insert coin(s). Once the correct AMOUNT TO START has been inserted, the L.C.D. will display
“SELECT TEMPERATURE”.
c. Select temperature by pressing “HI”, “MED”, or “LO”. The cycle will start and the L.C.D. will display
the Dry Cycle selected and the remaining time.
d. The dryer will continue through the drying and cooling cycles, until the vended time has expired.
e. In Coin Mode, if more time is desired the customer will have to insert more credit. The dryer can be
stopped by pressing the “PAUSE” key or opening the main door. Press either “HI”, “MED”, or
“LOW” key after pressing the “PAUSE” key or closing the main door to restart the dryer.