Filter
Top Products
113215-5 www.amdry.com 15
4. Electrical Connections
A wiring diagram is located inside the control box for connection data.
If local codes permit, power to the dryer can be made by the use of a flexible U.L. listed power cord/pigtail
(wire size must conform to rating of dryer), or the dryer can be hard wired directly to the service breaker
panel. In both cases, a strain relief must be installed where the wiring enters the dryer.
IMPORTANT: A separate protected circuit must be provided to each pocket.
Single-Phase (1ø) Hookup
The electrical input connections on
ALL single-phase (1ø) dryers are made into the junction box located at
the upper rear of the dryer. A separate circuit servicing each pocket must be provided.