Filter
Top Products
40 American Dryer Corp. 113386-14
90 DAYS
Remove lint from around basket (tumbler), drive motors, and surrounding areas. Remove lint from the gas valve
burner area with a dusting brush or vacuum cleaner attachment.
Impellor/fan (blower) shaft bearings should be lubricated using
Shell Alvania #2 grease or its equivalent.
Generically, this grease would be described as an NLGI grade 2 multipurpose industrial grease with a lithium
thickener and mineral base oil.
Check to make sure that the setscrews on the impellor/fan shaft bearings are tight.
NOTE: To prevent damage, avoid cleaning and/or touching the Direct Spark Ignitor.
Remove lint accumulation from inside.
6 MONTHS
Inspect and remove lint accumulation in customer furnished exhaust ductwork system and from dryer’s internal
exhaust ducting.
NOTE: THE ACCUMULATION OF LINT IN THE EXHAUST DUCTWORK CAN
CREATE A POTENTIAL FIRE HAZARD.
NOTE: DO NOT OBSTRUCT THE FLOW OF COMBUSTION AND VENTILATION AIR.
CHECK CUSTOMER FURNISHED BACK DRAFT DAMPERS IN THE EXHAUST
DUCTWORK. INSPECT AND REMOVE ANY LINT ACCUMULATION, WHICH CAN
CAUSE THE DAMPER TO BIND OR STICK.
NOTE: A back draft damper that is sticking partially closed can result in slow drying and shutdown
of the heat circuit safety switches or thermostats.
NOTE: When cleaning the dryer cabinet(s), avoid using harsh abrasives. A product intended for the
cleaning of appliances is recommended.
Check ALL V-belts for tightness and wear. Retighten, realign, or replace if required.
NOTE: V-belts should be replaced in matched sets (pairs).
B. ADJUSTMENTS
7 DAYS AFTER INSTALLATION AND EVERY 6 MONTHS THEREAFTER
Inspect bolts, nuts, screws, setscrews, grounding connections, and nonpermanent gas connections (unions, shutoff
valves, and orifices). Impellor/fan V-belts, along with the motor and drive belts should be examined and
replaced if necessary. Tighten loose V-belts when necessary. Complete operational check of controls and
valves. Complete operational check of
ALL safety devices (door switches, lint drawer switch, sail switch,
burner, and hi-limit thermostats).
NOTE: The impellor/fan on the blower motor must be inspected and cleaned every 6 months.
!
!
!
!
!
!
!