Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
17
F232168
Rapid Advance (For Models With
Firmware ID Code “o2HC”, “o2UC”,
“ouHC” and “ouUC”)
NOTE: Rapid Advance (“Adv”) possible only if
configured for “Adv” in Setup mode. Refer to
Setup Mode.
How to Rapid Advance During All Steps
(Except First Fill Step)
1. Make sure Rapid Advance is enabled.
2. Press the advance (∧) keypad to advance to
desired step.
3. Display will show recalculated time remaining.
How to Rapid Advance (During First Fill
Step)
1. Make sure Rapid Advance is enabled.
2. While machine is filling with water, to advance to
the next step, press START (enter) keypad to turn
off the ability to change cycles.
3. Press the advance (∧) keypad to advance to
desired step.
4. Display will show recalculated time remaining.
NOTE: If control is set up for ‘EtiM’, the
remaining cycle time after using Rapid Advance
step is calculated as if control was configured for
‘PtiM’. This is because any time estimations
following advance would be inaccurate. After the
cycle ends, and the advance mode is disabled, the
next cycle display remaining cycle time based on
the ‘EtiM’ configuration.
Agitation Step
Advance the cycle by pressing (∧) keypad to skip to
the drain step. Filling, supply flushing and other
signals turn off. Cycle remaining time is recalculated
as the total remaining time after the agitation.
Drain Step
Advance the cycle by pressing (∧) keypad to skip the
drain step and the following spin step. The spin step is
skipped because the drain step needs to be completed
to balance the load. The next step after the spin
begins. Cycle remaining is recalculated as the total
remaining time after the drain and spin steps.
Spin Step
Advance the cycle by pressing (∧) keypad to skip the
spin step. The next programmed step after the spin
begins. Cycle remaining is recalculated as the total
remaining time after the spin step.
Test Cycle
The test cycle provides a convenient means of
troubleshooting and testing all machine functions
quickly.
● Enter Program Mode.
● Press the (∨) key. Display shows “tESt”.
● Return the Program/Run switch to the right.
● Press START key. The door locks and the test
mode starts.
● Display shows “SPC?”. This is a factory test
procedure. Ignore it and the machine will
advance into the test cycle after about
five seconds.