Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
F232168
16
Abnormal Conditions
Door Open During Operation
If the control senses either a momentary or sustained
open door while the machine is operating in a wash
cycle, the control immediately attempts to halt rotation
of the cylinder, and all outputs not required to effect
rapid halting of the cylinder rotation de-energize
immediately. The message “door” then displays as
long as the condition persists. Regardless of the
duration of the open door condition, once it is
recognized by the control, the control aborts the cycle
and goes to the stop routine if the door is closed
(otherwise all outputs turn off and display shows
“door”).
Excessive Fill Time
Fill times exceeding 10 minutes cause the cycle to
abort. Display flashes “StOP”/“FILL” or “ErFL” and
sounds the buzzer for ten seconds prior to entering the
stop routine (display shows “01” minutes remaining
while in the stop routine). The Fill Error Count will
increase by one. Refer to Cycle and Error Count
section.
Door Will Not Open
At the end of a cycle or at power up, before the control
will allow the door to unlock, control checks for low,
medium or high water level. Control allows the door to
unlock only when machine is empty. If any water level
is indicated, display shows “FULL” while keeping all
outputs off. This condition could indicate a slow drain
system or a mechanical blockage of the drain. Contact
a qualified service technician about display on control.
Excessive Drain Time
If cycle aborts, with display flashing “Erdn” with
buzzer sounding, the machine did not empty after
4 minutes 15 seconds in a drain step.
Drain Error (For Models With Firmware ID
Code “o2HC”, “o2UC”, “ouHC” and
“ouUC”)
If machine has not drained within 4 minutes 15
seconds, display flashes “Erdn”, time remaining, and
beeper beeps. The beeper stops beeping after 30
seconds while display flashes “Erdn”until machine
empties. If machine empties, ending Drain Error
condition, display stops flashing, beeper turns off, and
remaining cycle time displays as the cycle resumes.
If machine does not empty, display continues flashing
“Erdn”. The drain error counter increases by one.
Refer to Cycle and Error Count.
Temperature Probe Sensor Problem
If display shows “tSFL”, “-19c”, or “00F”, the
machine has a temperature sensor failure. This could
mean the sensor is not connected or the sensor has
failed. If replacing the probe does not correct this,
consult an authorized service person.
Frame Limit Switch Trip
If the display is flashing “baL/door”, the frame limit
switch may have tripped during a high speed spin. This
may be due to the door momentarily opening during
the high speed spin. Contact a qualified service
technician if this occurs.