Filter
Top Products
Safety
24 F232073
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Cycle Programming (Continued)
11. Use the Up or Down key to select the desired
spin time. Set this value to zero to skip the spin
step. Press the Start key. The display will now
show the identifier for next program segment.
Note: An automatic 40-second coast-down follows
every high-speed spin. For all spins except the final
spin, this coast-down occurs during the fill for the
following segment. Therefore, cycle time is not
increased for coast-downs following all but the final
spin.
12. Press the Stop key at any time to complete the
cycle programming procedure.
Chemical Injection Supply System
The external supply connection ports are designated
1, 2, 3, and 4, in that order, viewed from the rear of
the machine, top to bottom. The supply dispenser
compartments are designated 1, 2, and 3, in that
order, viewed from the front of the machine, left to
right.
The chemical injection supply nozzles located in
their respective supply compartments function as
follows: supply nozzle 1 empties into compartment
1, supply nozzles 2 and 4 empty into compartment
2, and supply nozzle 3 empties into compartment 3.
See Figure 4.
Figure 4
Compartment 1 flushes with each fill. Compartment
2 flushes when the program calls for supply 2
during a fill. Compartment 3 flushes when the
program calls for supply 3 during a fill.
Note: Compartment 2 does not flush when supply 4
is called for in a program.
Supply Dispenser
Compartments
Chemical Injection
Supply Nozzles
1
2
3
1
2
4
3
B009RE3A