Filter
Top Products
F232073 17
Safety
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Supply Dispenser
Both liquid and powder supplies may be added by
raising the flexible cover of the dispenser. Liquid
supplies may also be injected directly into the
supply dispenser by an external chemical supply
system.
Note: When a liquid supply is manually added to
the machine through supply compartments 1 or 2,
that liquid is immediately dispensed to the laundry
load. Therefore, when adding supplies such as
liquid detergent and bleach to the machine,
coordinate the addition of the supply with the
appropriate cycle segment. Add softener to
compartment 3 at the beginning of the cycle. The
machine automatically dispenses softener at the
appropriate time.
Cycle Selection
Note: Press keys at their centers just hard enough to
activate them.
Press the Up or Down key until the desired cycle
number is displayed. Press the Start key to start the
cycle. For a more detailed description of the
preprogrammed cycles, see the cycle charts at the
end of the Programming section.
If the computer detects that the door is not properly
closed when the Start key is pressed, the display
will read “door” until the door is closed and locked.
Press the Start key again to begin the desired cycle.
Cycle Execution
A cycle can be stopped at any time by pressing the
Stop key. The machine will go to the stop routine.
When the routine is complete, the door may be
unlocked.
To display the temperature of the water while a
cycle is running, press the Up key. To display the
number of the cycle in progress, press the Start key.
Note: The display pauses the cycle time countdown
during the fill, heat, and drain steps.
Each of the 30 cycles consists of 8 segments:
Prewash, Wash, and Fills 1 – 6. A description of the
various steps in a cycle segment follows:
Fill
After the Start key is pressed, the door locks, the
drain closes, and the machine begins filling to the
programmed level; each programmed segment
begins with a fill. The display counts down the
remaining cycle time in minutes and seconds while
the cycle is running.
If a supply is programmed in a step, the supply
dispenser will flush during the fill of that segment.