Filter
Top Products
Safety
18 F232073
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Cycle Execution (Continued)
If the machine is connected to an external chemical
supply system, the programmed supply will begin
10 seconds into the fill. The supply will remain on
until the programmed water level is reached, or
until 60 seconds have elapsed, whichever happens
first.
If the computer does not receive a signal that water
level has been attained within 30 minutes, it will
alternately flash “STOP” and “FILL” and sound the
on-board beeper for ten seconds; it will then initiate
the stop routine.
Wash
Standard Wash
As soon as water level is reached (and any
programmed temperature is reached), the displayed
time begins counting down at one-second intervals.
All but three cycles use the standard wash agitation.
This agitation repeats for the first programmed time
duration in the prewash, wash, and fill segments.
The standard wash agitation sequence:
12 seconds counterclockwise at wash speed
A 3-second pause
12 seconds clockwise at wash speed
A 3-second pause
Note: While a cycle is in progress, pressing and
holding the Start key will cause the current cycle
number to be displayed. Pressing and holding the
Up key while a cycle is running will display the
temperature inside the sump.
Gentle Wash
Cycles 8, 16, and 24 use a gentle wash agitation in
place of the standard wash agitation. This agitation
repeats for the programmed segment time duration
in the prewash, wash, and fill segments.
The gentle wash agitation sequence:
3 seconds counterclockwise at wash speed
A 12-second pause
3 seconds clockwise at wash speed
A 12-second pause
Heat
If the segment contains a heat step, the machine
begins heating after the water has reached the
programmed level.
Note: If the water does not reach the programmed
temperature in 30 minutes, the computer progresses
to the wash step.