Filter
Top Products
Safety
16 F232073
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Start-Up
Turn on the main power source (circuit breaker or
cut-off switch on the wall).
An identification code will appear for
approximately five seconds. Then the display will
flash “hold” for thirty seconds.
The display will then read “CY” followed by a two-
digit cycle number (01 – 30) to indicate that a cycle
can be selected. This display will be shown at all
times that power is on between cycles, indicating
that the door-unlock solenoid will function if the
door-unlock button is pressed. The machine is then
ready for loading and unloading.
Opening Door
Press and hold the door-unlock button on the left
side of the control panel. Press the round button on
the door handle and turn the door handle downward.
Loading
Load the machine to full capacity whenever
possible, but do not exceed the rated dry-weight
capacity of the machine if the fabric to be washed is
quite dense, closely woven, and heavily soiled.
Overloading can result in an inferior wash. The
operator may need to experiment to determine load
size based on fabric content, soil content, and level
of cleanliness required.
Partial loads are a waste of energy, water, and
chemicals, and cause greater machine wear than full
loads. Partial loads also increase the possibility of a
severe out-of-balance condition.
When loading is complete, ensure that all fabric is
inside the basket. Then close and lock the door by
rotating the door handle counterclockwise until the
door handle pushbutton pops out. The machine
should not start or run unless the door is both closed
and locked.
Note: When washing items which may disintegrate,
such as mop heads or sponges, use laundry net bags
to prevent drain blockage.
Be careful around the open door, particularly
when loading from a level below the door.
Impact with door edges can cause personal
injury.
&$87,21
SW025
Never operate the machine with a bypassed or
disconnected out-of-balance switch. Operating
the machine with severe out-of-balance loads
could result in personal injury and serious
equipment damage.
:$51,1*
SW010
Check the door safety interlock daily before the
machine is placed in operation.
&$87,21
SW024