Filter
Top Products
F232061
1
Table of Contents
Operation/Programming
Safety
Key to Symbols ................................................ 4
Operator Safety ................................................ 5
Safe Operating Environment ............................ 6
Environmental Conditions ............................ 6
Machine Location ......................................... 7
Input and Output Services ............................ 7
AC Inverter Drive ......................................... 8
Misuse .............................................................. 8
Operation
Customer Service ............................................. 9
Machine Familiarization Guides....................... 9
Theory of Operation ......................................... 12
V-Computer .................................................. 12
Keypad .......................................................... 13
Conditions Monitored by the Computer ....... 14
Display Indications ....................................... 15
Start-Up ............................................................ 16
Opening Door ................................................... 16
Loading ............................................................ 16
Supply Dispenser ............................................. 16
Cycle Selection ................................................ 17
Cycle Execution ............................................... 17
Fill ................................................................. 17
Wash ............................................................. 18
Drain ............................................................. 18
Spin ............................................................... 18
Stop Routine ................................................. 19
Balance Detection ............................................ 19
Overtravel Limit Switch................................ 19
Test Cycle ......................................................... 19
Programming
Key Functions in Programming Mode ............ 21
Setup Mode ...................................................... 21
Degrees Displayed in Fahrenheit or
Celsius ...................................................... 22
Auxiliary Heat .............................................. 22
Setting Display to Flash “PAY” and a
Start Amount............................................. 22
Programming Start Price............................... 22
Coin 1 Denomination.................................... 23
Coin 2 Denomination.................................... 23
Cycle Count ..................................................... 23
Cycle Programming ......................................... 23
Segment Programming ................................. 23
Test Cycle......................................................... 25
Cycle Segment Charts ..................................... 27
V-Computer Standard Coin Cycles.................. 30