Filter
Top Products
Operation
16
F232061
Start-Up
Turn on the main power source (circuit breaker
or cut-off switch on the wall).
The display shows an identification code for
approximately five seconds. The display then
flashes “hold” briefly.
The display then shows the vend price or
alternately flashes the vend price and “PAY,”
depending upon which setting was prompted
in the “FLSH”/“nFLS” setup option.
Opening Door
Press the round button on the door handle and
turn the door handle downward.
Loading
Load the machine to full capacity whenever
possible, but do not exceed the rated dry-
weight capacity of the machine if the fabric to
be washed is quite dense, closely woven, and
heavily soiled. Overloading can result in an
inferior wash. The operator may need to
experiment to determine load size based on
fabric content, soil content, and level of
cleanliness required.
Partial loads are a waste of energy, water, and
chemicals, and cause greater machine wear
than full loads. Partial loads also increase the
possibility of a severe out-of-balance
condition.
When loading is complete, ensure that all
fabric is inside the basket. Then close and
lock the door by rotating the door handle
counterclockwise until the door handle
pushbutton pops out. The machine should not
start or run unless the door is both closed
and locked.
Note:
When washing items which may
disintegrate, such as mop heads or sponges,
use laundry net bags to prevent drain blockage.
Supply Dispenser
Both liquid and powder supplies may be added
by raising the flexible cover of the dispenser.
Be careful around the open door,
particularly when loading from a level
below the door. Impact with door edges
can cause personal injury.
SW025
CAUTION
Never operate the machine with a bypassed
or disconnected balance system. Operating
the machine with severe out-of-balance
loads could result in personal injury and
serious equipment damage.
SW039
WARNING
Check the door safety interlock daily before
the machine is placed in operation.
SW024
CAUTION