Filter
Top Products
Programming
22
F232061
Setup Mode
(Continued)
To enter setup mode, press the Stop key while
the display is showing the temperature in the
sump. Once in setup mode, use the Up or
Down key to change the selected option. Use
the Start key to accept the selected option and
move on to the next one. Press the Stop key to
exit setup mode.
Degrees Displayed in Fahrenheit
or Celsius
This setup option affects the programming and
display of all temperatures. If “FAr”
is selected, all temperatures will display
in Fahrenheit. If “CEL” is selected, all
temperatures will display in Celsius.
Acceptable ranges for programmable
temperatures are 75°F–200°F or 25°C–93°C.
Auxiliary Heat
Heat is a dedicated output of the V-computer,
which controls an optional heat source. If
“noHt” is selected, the heat output will never
energize during a cycle (except briefly in the
test cycle to ensure that the output functions
properly). If “HEAt” is selected, the output
will energize during a cycle if the three
following conditions are true:
• A nonzero heat temperature
is programmed.
• The computer senses that the present
temperature is below the programmed
target temperature.
• At least a low water level is present in
the machine.
Note:
Do not enable the auxiliary heat setup
option on machines not equipped with
auxiliary heat. The machine will pause for
30 minutes during any cycle segment where
the fill water temperature does not equal or
exceed the programmed value of the heat step.
Setting Display to Flash “PAY” and a
Start Amount
If the display is programmed to flash “PAY”
and a start amount, it will read “FLSH.”
Otherwise the display will read “nFLS.”
Press the Up or Down key to change from
one to the other.
Programming Start Price
The display will read “Strt” for one second,
followed by “A
n
t” for one second, then the
programmed start price. For example, if the
start price is $1.50, the display will read “150”
for start price.
Press the Up key to increase the start amount,
or the Down to decrease the start amount.
Note:
When using the Up or Down key to
increase or decrease the start amount, holding
the key down for several seconds will cause
the displayed value to change more rapidly.