Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
29
F232157
Permanent Factory Diagnostic Test
Cycle
Warm fill to low water level Display flashes “bFIL”/ “LO” (keypad WASH LED on), no agitation
Outputs: Motor OFF, Drain closed, hot fill on, cold fill on
Pause after reaching low
water level
Display shows “LO” (no flashing), LOW water level dot ON, no agitation (keypad WASH
LED on); pauses until operator presses (
∧) keypad
Outputs: Motor OFF, Drain closed
Drain (can advance to next
step by pressing (
∧) keypad
here)
Display shows “drAI”, no agitation (keypad WASH LED on)
Outputs: Motor OFF, Drain open
Cold fill to medium level Display flashes “CFIL”/ “
nEd” (keypad WASH LED on), no agitation.
Outputs: Motor OFF, Drain closed, cold fill on
Pause after reaching
medium water level
Display shows “
nEd” (no flashing), LOW and MEDIUM water level dots ON no agitation
(keypad WASH LED on); pauses until operator presses ^ keypad
Outputs: Motor OFF, Drain closed
Hot fill to high level Display flashes “HFIL”/ “HI” (keypad WASH LED on), no agitation.
Outputs: Motor OFF, Drain closed, hot fill on
Pause after reaching high
water level
Display shows “HI” (no flashing), LOW, MEDIUM, & HIGH water level dots ON, no
agitation (keypad WASH LED on); pauses until operator presses ^ keypad
Outputs: Motor OFF, Drain closed
Heat to 45°C (110°F)
SKIPS THIS STEP
if
machine does not have heat
capability (“noHt” selected
in SETUP Mode)
Display flashes “HEAT” and the temperature inside the machine while agitating in forward
and reverse; continues until temperature reaches 45°C (110°F), then advances to next step.
(keypad WASH LED on)
Outputs: Motor alternates forward 12 seconds, off 3 seconds, reverse 12 seconds, off
3 seconds and repeats; Drain closed; Heat ON UNTIL 45°C (110°F) reached
Extra fill spare – 5 seconds
(skips this if not selected in
SETUP Mode)
Display flashes “EFIL” (keypad RINSE LED on)
Outputs: Motor alternates forward 12 seconds, off 3 seconds, reverse 12 seconds, off
3 seconds and repeats; Drain closed; “S4” output ON.
Supply 1: 5 seconds (Heat
signal also on (IF at least
low water level – verifies
output even if not heated
model)
Display shows “SUP1” (keypad WASH LED on)
Outputs: Motor alternates forward 12 seconds, off 3 seconds, reverse 12 seconds, off
3 seconds and repeats; Drain closed; Supply 1 ON, HT ON, cold fill ON
Supply 2: 5 seconds (Heat
on also)
Display shows “SUP2” (keypad ADD BLEACH LED on)
Outputs: Motor alternates forward 12 seconds, off 3 seconds, reverse 12 seconds, off
3 seconds and repeats; Drain closed; Supply 2 ON, HT ON, cold fill ON
Supply 3: 5 seconds (Heat
on also)
Display shows “SUP3” (keypad RINSE LED on)
Outputs: Motor alternates forward 12 seconds, off 3 seconds, reverse 12 seconds, off
3 seconds and repeats; Drain closed; Supply 3 ON, HT ON, cold fill ON
Pause 5 seconds, then
Forward wash speed –
2 minutes
Display shows “For”
Outputs: Motor operates wash speed forward; drain closed
Table 4 (Continued)