Filter
Top Products
Installation
34
F232058
Figure 20
4. Wiring the drain valve on the canister/
filter/pump assembly (See Drawing No.
633583, included with kit):
a. Remove drain valve motor cover on the
washer-extractor.
b. Extend 2-conductor cable already
installed on the drain valve on the
canister/pump/filter assembly to the left
drain valve on the washer-extractor.
c. Splice 2-conductor cable with the left
drain valve motor leads, using the blue
female quick-disconnect terminals
included in the kit.
Rear Panel
1/4-20 Fiberlock Nut
1/4-20 x 5/8 Screw
Recirculation
Adapter Plate
1/4-20 Fiberlock Nut
1/4-20 Fiberlock Nut
1/4-20 x 5/8 Screw
No. 48
Hose Clamp
Wet Clean Drain
Adapter Plate
1/4-20 x 5/8 Screw
1/4-20 Fiberlock Nut
Flex Drain Hose
Base Frame
Recirculation inlet hose
No. 28 Hose Clamp
Capped with Rubber Plug
Before Inlet Hose Installation
Shell
Capped with Sump
Plug Before Hose
Installation
Recirculation
Drain Outlet
Sump
Inner Drain Hose
No. 48
Hose Clamp
Premium Wet Clean Module Installation – Internal Plumbing
Z015I3A