Filter
Top Products
21
Installation
F232058
Figure 11
6. Remove the spacers carefully, allowing
the machine to settle into the wet grout.
7. Position the mounting bolt washers and
locknuts on the anchor bolts and
fingertighten locknuts to machine base.
8. After the grout is completely dry, tighten
the locknuts by even increments – one
after the other – until all are tightened
evenly and the machine is fastened
securely to the floor.
9. Remove the four red transport brackets
used to secure the machine during
shipping. See Figure 12.
U098I