Filter
Top Products
35
What to do if...
What to do if...
Certain problems are due to lack of simple maintenance or oversights, which can
be solved easily without calling out an engineer. Before contacting your local
Service Centre, please carry out the checks listed below.
During machine operation it is possible that the yellow pilot light of button
8
blinks, one of the following alarm codes appears on the display and at the same
some acoustic signals sound every 20 seconds to indicate that the machine is
not working:
•
E10 : problem with the water supply
•
E20 : problem with the water draining
•
E40 : door open.
Once the problem has been eliminated, press button
88
to restart the programme.
If after all checks, the problem persists, contact your local Service Centre.
Problem Possible cause/Solution
The washer-dryer does not start:
The door has not been closed. E40
• Close firmly the door.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse or the fuse in the plug has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the
button
8 has not been depressed.
• Please turn the selector dial and press button 8
again.
The delay start has been selected.
• If the laundry is to be washed immediately, cancel
the delay start.
The Child safety lock has been activated.
• Deactivated this device.
The machine does not fill:
The water tap is closed. E10
• Open the water tap.
The inlet hose is squashed or kinked.
E10
• Check the inlet hose connection.
The filter in the inlet hose is blocked.
E10
• Clean the water inlet hose filter.
The door is not properly closed.
E40
• Close firmly the door.
132962861.qxd 29/05/2008 11.35 Pagina 35