Filter
Top Products
3. Set the hose correctly by loosening the ring
nut.
After positioning the inlet hose, be sure to
tighten the ring nut again to prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied with
the appliance.
Installation should comply with local water
authority and building regulations requirements. A minimum water pressure of
0.05 MPa is required for safe operation of the appliance.
If you cannot make the cold water connection direct from the rising mains, you
may be able to operate the appliance from your cold water storage system. There
should be a minimum distance of between the appliance’s inlet and the bottom of
the water storage tank.
The inlet hose must not be lengthened. If it is too short and you do not wish to
move the tap, you will have to purchase a new, longer hose specially designed for
this type of use.
Water drainage
This appliance is designed to be permanently plumbed into your home's drainage
system using one of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using
the “U” piece” supplied.
Place the drain hose into your
standpipe, which should have an
internal diameter of approximately
38mm thus ensuring there is an air
break between the drain hose and
standpipe.
43
P1199
U piece
supplied
Installation
30 cm (12")
38 mm (1.5)
standpipe
diameter
132962861.qxd 29/05/2008 11.35 Pagina 43