Filter
Top Products
18
Use
Cancelling a programme
Turn the selector dial to
O
to cancel a programme which is running. Now you
can select a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing button 8. After a few minutes the
door can be opened.
If the door remains locked, this means that the machine is already heating or
that the water level is too high.
If you cannot open the door but you need to open it you have to switch the
machine off by turning the selector dial to
O
. After a few minutes the door can
be opened (pay attention to the water level and temperature!). After
closing the door, it is necessary to select the programme and options again and
to press button
8.
At the end of the programme
The machine stops automatically, the pilot light of button 8, the pilot light 10.1
or 10.2 go off and a blinking 0 will appear on the display. Some acoustic signals
sound. The door can be opened.
If a programme or an option that ends with water still in the tub has been
selected, the light of the Rinse Hold option is lit and the the door remains locked
to indicate that the water must be emptied out before opening the door.
Obey the instructions below to empty out the water:
● turn the programme selector dial to
O
● select the DRAIN or SPIN programme
● reduce the spin speed if needed, by pressing the relevant button
● press button 8
● when the programme has finished the display shows a blinking 0. The door can
now be opened.
Turn the programme selector dial to
O
to switch the machine off. Remove the
laundry from the drum and carefully check that the drum is empty. If you do not
intend to carry out another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
132962861.qxd 29/05/2008 11.34 Pagina 18